As an Amazon Associate I earn from qualifying purchases.

3v for rx, 1x 4g aux antennaipEX, 1x GPS antennaIPEX. Drivers - very important to install the corresponding driver before connecting to the Internet.
If failed, it won't be able to receive the 4G signal and get it working. Application - widely used for quick network connection which enables you to let your devices like Windows, Linux, Android connect to 4G network directly after installing related driver and insert your local SIM card.



01 per MB. Fully compatible with raspberry pi models that have the 40-pin GPIO header 4, 2, 3, A+, B+, Zero.


Upgrade esp32 lora development board with 868/915mhz antenna, softap and w i- f i Direct modes. One is used to send messages and one is used to receive messages.

Perfectly support arduino, integrated encryption algorithm, compatible with AT command and GPS, LoRaWAN 1.02 support. Onboard 096-inch 128*64 dot matrix oled display, battery power, which can be used to display debugging information, and other information.


Uart communication, serial AT commands controlSupport. Comes with development resources and manual MicroPython examples.
1. Botletics
#ad
Botletics SIM7000 LTE CAT-M1 NB-IoT Cellular + GPS + Antenna Shield Kit for Arduino SIM7000A
#adBotletics #ad - Operates on lte cat-m1 and/or nb-IoT technology + GPS + temperature sensor. Kit includes dual flexible LTE/GPS antenna and stacking female header kit. Ultra low-power mode drawing < 8uA, ideal for battery-powered IoT devices + LiPo battery charging.More information #ad
Detailed documentation, Arduino library, wiki, and code examples on Github + community forum to ask questions. Directly compatible with Arduino Uno, Mega, and Leonardo + easy connection for other logic voltages.Brand | Botletics #ad |
Manufacturer | Botletics #ad |
Height | 0.5 Inches |
Length | 2.3 Inches |
Width | 2.1 Inches |
Part Number | C2I_INV_B07H3XKNLH_R |
Model | C2I_INV_B07H3XKNLH_R |
More information #ad
2. EXVIST
#ad
EXVIST 4G LTE USB Dongle W/EG25-G LCC IoT/M2M-optimized LTE Cat 4 Module SIM Card Slot GPS for Global
#adEXVIST #ad - Advantages - equipped with quectel eg25-g iot/m2m-optimized LTE Cat 4 module, which enables it be able to delivers maximum data rates up to 150Mbps downlink and 50Mbps uplink. Interfaces - 1x micro sim card slot corner facing outside when plugging in the siM card, 1x 4G main antennaIPEX, TX, 1x TTL3.3v for rx, 1x 4g aux antennaipEX, 1x GPS antennaIPEX. Drivers - very important to install the corresponding driver before connecting to the Internet.
More information #ad
Reliability - adopts industrial electric circuit design, DC-DC power chip to make sure the module can always be working fine and never offline even under severe environment. If failed, it won't be able to receive the 4G signal and get it working. Application - widely used for quick network connection which enables you to let your devices like Windows, Linux, Android connect to 4G network directly after installing related driver and insert your local SIM card.
Brand | EXVIST #ad |
Manufacturer | EXVIST #ad |
Height | 0.31 Inches |
Length | 2.59 Inches |
Weight | 0.03 Pounds |
Width | 1.22 Inches |
Part Number | 4UDEG25G |
Model | 4UDEG25G |
Warranty | 1 year manufacturer |
More information #ad
3. IOTElectronic
#ad
GSM/GPRS/GNSS Bluetooth HAT Expansion Board GPS Module SIM868 Compatible with Raspberry Pi 2B 3B Zero Zero W Support Make a Call,Send Messagess,DataTransfer IOT
#adIOTElectronic #ad - Supports sms, ftp, phone call, DTMF, MMS, http, gprs, email, etc. Package content 6 pcs: gsm/gprs/gnss hat x1, gps external antenna b x1, Bluetooth Antenna x1, usb type a plug to micro plug cable x1, GSM Antenna x1, RPi screws pack 2pcs x1.More information #ad
Compatible with raspberry pi:Comes with development resources and manual examples for Raspberry Pi/Arduino/STM32. Support gps, lbs base station positioning, Glonass, COMPASS, omni-positioning.Brand | IOTElectronic #ad |
Manufacturer | IOTElectronicWS #ad |
Height | 0.79 Inches |
Length | 2.56 Inches |
Width | 1.18 Inches |
Part Number | NA |
Model | NA |
More information #ad
4. M5Stack
#ad
M5Stack Core2 ESP32 IoT Development Kit for AWS IoT EduKit
#adM5Stack #ad - Capacitive touch screen; built-in pdm microphone, 10 x rgb leds; sd card slot supports up to 16GB; Built-in 500mAh lithium-ion battery, reset button, Speaker, amplifier, vibration motor, power button, i2s codec, RTC, 6-axis imu, power indicator, equipped with a power management chip;.More information #ad
Supports freertos, microPython, UIFlow, Ar duino development frameworks;. Reference hardware kit for use with AWS IoT EduKit;. Esp32-d0wdq6-v3, supports 2. 4ghz wifi; 16m flash, 8m psram; built-in ATECC608 Trust&GO hardware encryption chip;. Validated through AWS Device Qualification Program.Brand | M5Stack #ad |
Manufacturer | M5Stack Technology Co., Ltd. #ad |
Weight | 0.24 Pounds |
Part Number | K010-AWS |
More information #ad
5. Sixfab
#ad
Hardware | Global IoT SIM Card w $25 Free Credit | Free Cloud Software | Remote Network Monitoring | Remote Terminal Access, Raspberry Pi 4G/LTE Cellular Modem Kit
#adSixfab #ad - Optional data packages are available for high data usage. 25 free credit coupon. Don't pay for inactive SIMs. Lifetime free sixfab software includes remote terminal & dashboard for your Raspberry Pi.01 per MB. Fully compatible with raspberry pi models that have the 40-pin GPIO header 4, 2, 3, A+, B+, Zero.
More information #ad
Start without paying for the sim & data. Simple pay-as-you-go Pricing $2 Monthly Active SIM Cost. All necessary components for connecting your Raspberry Pi to the 3G/4G-LTE networks. Single-step setup. Data speeds up to 150mbps downlink and 50Mbps uplink, optimized for M2M and IoT applications.Brand | Sixfab #ad |
Manufacturer | Sixfab #ad |
Part Number | B40 |
More information #ad
6. Geekstory
#ad
Geekstory BN-880 GPS Module U8 with Flash HMC5883L Compass + GPS Active Antenna Support GPS Glonass Beidou Car Navigation for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller
#adGeekstory #ad - So you do not need to reset next time when you use it. Dits data level is ttl or rs-232, default ttl level. Bn 880 gps module is dual module compass, with and electronic compass IC HMC5883L. When you use it for raspberry Pi, there is no driver needed but you need to install software.More information #ad
To make it be rs232 output, you need to use one TTL to RS232 converter cable. Bn 880 gps module has flash to save configuration. Bn-880 is suitable for open source flight controller, not for flight control with SCM.Brand | Geekstory #ad |
Manufacturer | Geekstory #ad |
Height | 0.39 Inches |
Length | 1.18 Inches |
Weight | 0.04 Pounds |
Width | 1.18 Inches |
Part Number | Beitian BN |
Model | FZ2920 |
More information #ad
7. MakerFocus
#ad
MakerFocus ESP32 LoRa 32 V2, Smart Home, ESP32 Development Board W I F I Bluet ooth LoRa Dual Core 240MHz CP2102 with 0.96inch OLED Display Included 868/915MHZ Antenna for Smart Cities, Smart Farms
#adMakerFocus #ad - Documents: please get the link from the product description below. Note: this item comes unassembled, soldering of headers is required. Board friendly, lithium battery charging circuit and interface, fit to breadboard.Upgrade esp32 lora development board with 868/915mhz antenna, softap and w i- f i Direct modes. One is used to send messages and one is used to receive messages.
More information #ad
High reliability, transmission distance measured open area communication distance 2. 8km; receiver sensitivity up to - 139 dBm, UDP continues to throughput by 135 Mbps. 096-inch blue esp32 oled display, space of pins is 2. 54*23mm, cp2102 usb to serial chip. If you want to use the lora feature, Station, it supports Sniffer, you need two esp32 lora modules.Brand | MakerFocus #ad |
Manufacturer | MakerFocus #ad |
Height | 0.05 Inches |
Length | 2.05 Inches |
Weight | 0.01 Pounds |
Width | 1 Inches |
Part Number | 33MKMJHOXQ57B34W2CGJ145XL |
Model | 8541549242 |
More information #ad
8. DIYmall
#ad
LoRa GPS Module LoRaWAN HTCC-AB02S 868MHz/915MHz Development Board with 0.96 inch OLED Display CP2102 ASR6052 Chip LoRa Kit Ultra Low Power Design for Intelligent Scene Arduino IoT
#adDIYmall #ad - Micro usb interface with complete esd protection, convenient for program downloading, rf shielding, and other protection measures;Integrated CP2102 USB to serial port chip, short circuit protection, debugging information printing.Perfectly support arduino, integrated encryption algorithm, compatible with AT command and GPS, LoRaWAN 1.02 support. Onboard 096-inch 128*64 dot matrix oled display, battery power, which can be used to display debugging information, and other information.
More information #ad
Onboard solar energy management system, battery power detection, integrated lithium battery management system charge and discharge management, can directly connect with a 5.5~7v solar panel; Onboard SH1. 25-2 battery interface, overcharge protection, USB / battery power automatic switching. Based on asr6052, those chips are already integrated the PSoC 4000 series MCU ARM Cortex M0+ Core and SX1262.Brand | DIYmall #ad |
Manufacturer | Heltec Automation Technology Co., Ltd #ad |
Warranty | Yes |
More information #ad
9. Doudou
#ad
2pcs GT-U7 GPS Module Navigation Satellite Positioning Compatible with NEO-6M 51 MCU STM32 High Sensitivity Low Power Consumption High-Precision Positioning Suitable for Vehicles
#adDoudou #ad - Working voltage: 3. 6v-5v or use micro USB to directly supply power. The module comes with LED signal indication and data backup battery. Compatible with neo-6m 51 MCU STM32. Gt-u7 module, miniaturization, extremely high tracking sensitivity, low power consumption, with high sensitivity, large coverage, high precision positioning under the narrow urban sky and dense jungle environment.More information #ad
Distribute active ceramic antenna for fast positioning.Brand | Doudou #ad |
Manufacturer | Doudou #ad |
Height | 0 Inches |
Length | 0 Inches |
Width | 0 Inches |
More information #ad
10. waveshare
#ad
Cat-MEMTC, Waveshare SIM7080G NB-IoT/Cat-MEMTC / GNSS Module for Raspberry Pi Pico NB-IoT, and GNSS Positioning with Global Band Support
#adwaveshare #ad - Onboard nano sim card slot, supports ONLY 1. 8v sim card 3v sim card is not available. Integrates 3. 7v li-po battery connector and recharge circuit, allows being powered from external rechargeable Li-po battery, or recharging it in turn.Uart communication, serial AT commands controlSupport. Comes with development resources and manual MicroPython examples.
More information #ad
2x led indicators, for monitoring the module operating status. Communication protocol support: tcp/udp/http/https/tls/dtls/ping/lwm2m/coap/mqtt. Gnss positioning support: gpS, GLONASS, BeiDou, and Galileo. Standard raspberry pi pico header, supports Raspberry Pi Pico series boards.Brand | waveshare #ad |
Manufacturer | Waveshare #ad |
Weight | 0.24 Pounds |
Part Number | Pico-SIM7080G-Cat-M/NB-IoT (EN) |
More information #ad